Your own programming socket

Remember last post, I say this " Or you can build your own one"? Ya, this post is talk about this how to build it..  but what is that? So is this:

Ok , what that? This is to replace the this : 

This is programming socket (maybe have other name ). SO how to build it?

First this is the material you need :

1) Stripboard

2) Some wire (at least 7 cm or depend on you)

3) programming socket (10 pin)

4) Solidering gun and soldering lead

5) cutting tool

Now let we start build : 

1) Cut your donutboard into 6X6 (or larger size )  

like this : for me, use 6X5

2) place programming socket like this

(behind)

(in front)

3 ) if the position ok for you, let start solder wire to it. 

4 ) First reference to this 

5) Then from here , choose 5 wire .You can use difference colour ,so that you can differentiate it easy , or you can use all same colour wire but with its label (Vpp , PGC, PGD, VDD and GND) . From here, we are not using Aux_Out and GND is connect together. 

6) After choose your wire, and the soldering gun are ready to use. You can start to build ... 

7) Before that, please cut off the connection here . So that, they are independent 

like this : (the red line)

8) Solder the programming socket into stripboard, make sure all the pin is solder and not to connect each other. After that, see this (similar as yours when you flip it?)

behind

in front

         

From here, you can refer to the this 

 

After refer , start solder with wire : for me this is the following colour

 - red : Vdd (pin 8)

 - black : GND  (pin 4 and pin 6)

 - green : Vpp (pin 3)

 - brown : PGD (pin 7)

 - white : PGC (pin 5)

Solder all wire except for GND. After you done, connect the pin 4 and pin 6 with soldering lead, then connect with its wire (black). 

From here, you are done to build your own programming socket with connector.

So, have a nice day.